Bridge cranes Chattanooga are similar to other types of cranes but different because the way that they are powered is by means of an electrodynamic lift system. In other words, these types of machines work in a more mechanical way as opposed to using hydraulic, mechanical or pneumatic systems for the lifting action. If you are interested in learning how to bridge cranes are put together, then this article will provide you with the basic information you need to know.

Parts of the Crane

The parts of a traditional crane setup include a platform, a run to the lift, and a run to the underlayment. On a typical crane, there are two wire ropes that are attached to the run and to the underlayment of the structure. At the same time, there is a hand crank that is used to extend the wires to the platforms, and the next part involves pulling the wire rope back into the run. Essentially, it is a two-step process.

Initial Setup

Once the maximum number of wire rope runs is determined, it is important to determine the platform on which the crane platform will be set up. If you do not have a suitable platform, your crane will not perform to the best of its ability. Typically, the platforms are placed on the ground so that the crane can be easily guided to the desired location. You will need to know the height of the structure that you want the platform to be installed on. Again, this will be based on how deep you want to install the platform and how steep the ground is in the area where you intend to place the crane. If you choose the wrong angle, your crane could tip over.

Extend the Run Wire

Once the location and platform are decided upon, you can continue to the next step of setting up the crane platform. You need to extend the run wire on the crane platform to the run wire harness attached to the engine. Then, you should tie one end of this harness to the center point of the run. This will provide tension on the run wire.

The last step of how bridge cranes are set up involves securing the deck beams to the framework. Typically, this is done with ties. In addition, you will often find that you need to use screws or nails. However, when installing your crane, you should remember that a single-point tie is usually the best choice.